- Make sure this fits by entering your model number.
- Higher RF output power (+2.5dBm output power as compared to -2.5dBm 400 series Z-wave module)
- Adopt Z-Wave protocol to secure the success of wireless two way communication
- Very low no load power consumption (2009/125/EC no. 1275/2008
- UL,FCC PART 15B+C LVD; Resistive load 1500W;
- Z WAVE CERTIFICATED NO ZC08-13070002
This smart energy plug-in switch is a transceiver which is a Z-WaveTM enabled device and is fully compatible with any Z-WaveTM enabled network. Z-WaveTM enabled devices displaying the Z-WaveTM logo can also be used with it regardless of the manufacturer, and ours can also be used in other manufacturer’s Z-WaveTM enabled networks. Remote On/Off control of the connected load is possible with other manufacturer’s Wireless Controller. Each module is designed to act as a repeater. Repeaters will re-transmit the RF signal to ensure that the signal is received by its intended destination by routing the signal around obstacles and radio dead spots. This smart energy plug-in switch is able to detect voltage, current, power factor, Instant power wattage (5~1500W) and overload wattage (1550~1600W) of connected light or appliances. When detecting overload state, the switch will be disabled and its On/Off button will be lockout of which LED will flash quickly for 30 seconds. However, unplug and re-connect the Module will reset its overload condition to normal status. This plug-in switch can active sent out instant power wattage when variation over 5% or active sent out state change when manually push the ON/OFF button , this allows the controller to avoid polling the reading wattage value and state of the switch and can increase the efficiency of controller